Configuring In Wizard Mode - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Configuring in Wizard Mode

March 2013
This section describes how to use the Wizard Mode to configure
Dialogic® Brooktrout® Fax Software. You can use Wizard Mode to
get most typical systems up and running with minimal effort.
In Wizard Mode, after you answer the basic questions, the
Brooktrout Configuration Tool does the following.
Automatically creates the necessary configuration file
Installs and starts the drivers, if required
Starts the Boston Host Service
Wizard Mode requires that all the modules be of the same kind. All
modules are configured identically, that is, the modifications to the
configuration apply uniformly to all the modules.
You can use Wizard Mode in a homogeneous configuration where:
all the boards are of an identical type
or
the system contains only SR140 virtual boards.
In a non-homogeneous configuration, the Brooktrout Configuration
Tool will automatically start in Advanced Mode.
To use Wizard Mode refer to Dialogic® Brooktrout® Fax
Note:
Products Windows End User Guide.
Configuring in Wizard Mode
134