Installing The Software - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Installing the Software

Welcome to the Dialogic Brooktrout Setup Program
Program to install Boston API/Driver and Firmware Packages
*****************************************************************
*
*
*
*
*
*
*
*
*
*****************************************************************
The Brooktrout Driver package called "bfax" has been detected on your system. It
is OK to have both "BRKTBOSsetup" and "bfax" installed on your system. Since these
packages share common files, you may encounter errors during package removal.
March 2013
The Dialogic® Brooktrout® Fax Products SDK CD-ROM comes with
an installation program that uses rpm to install the files on your
hard drive. To use the program, follow the directions below. You
must be logged in as root or su to install/uninstall the software and
configure the driver.
Use the following procedure to install software files:
1. Mount the installation CD-ROM:
mount -t iso9660 -r /dev/cdrom /mnt/cdrom
2. Enter the command line to go to the Linux directory on the
CD-ROM drive:
cd /mnt/cdrom/Software/Linux/Redhat
3. Run the setup program by entering the following at a command
prompt:
sh ./setup.sh
The program displays a message if it does not detect an Intel
microprocessor and terminates. If the processor is Intel, the
program then displays a copyright notice and the following
information:
WARNING: This program is protected by copyright law
and international treaties.
Unauthorized reproduction or distribution of this
program, or any portion thereof, may result in severe
civil and criminal penalties, and will be prosecuted
to the maximum extent possible under law.
The program issues the following message only if you have the driver
called bfax, that runs on the TR114 board:
Installation Steps
*
*
*
*
*
*
*
*
*
36