Dialogic Brooktrout Digital Board Installation And Configuration Manual page 174

March 2013
on the first page of the transmission, the date and time it is sent and
an identification of the business or other entity, or other individual
sending the message and the telephone number of the sending
machine or such business, other entity, or individual. (The telephone
number provided cannot be a 900 number or any other number for
which charges exceed local or long-distance transmission charges.)
To program this information into your FAX machine, you should
complete the following steps:
Users:
To program this information into your fax machine,
follow the procedure described in your user manual.
Developers: You must include facilities in your application to enable
the user to enter the required information. Use the
BfvFaxHeader function with the Dialogic®
Brooktrout® board to place this information on each
transmitted page as required. You must also include, in
your user manual, instructions for entering this
information into your system.
Note to OEM Partners (final equipment assemblers):
For information related to power supply source requirements, signal
levels, etc., please refer to the installation instructions and general
specifications provided with this equipment.
The mounting of the approved unit in the final assembly must be
made so that:
The approved unit is isolated from exposure to any hazardous
voltages within the assembly.
Adequate separation and restraint of cables and cords must be
provided.
The circuitry from the approved unit to the telephone line must
be provided in wiring that carries no other circuitry (such as PC
or PR leads) unless specifically allowed by the rules.
PC board traces carrying tip and ring leads shall have sufficient
spacing to avoid surge breakdown.
The final assembler shall provide in the consumer instructions
all applicable customer information.
The approval label shall be placed on the exterior of the cabinet
for each type of approved device contained therein if the
approved device is enclosed in an assembly, and not readily
accessible.
Telecommunications Compliance Statements
174