Safety Compliance Statements; United States Of America And Canada - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Safety Compliance Statements

United States of America and Canada

March 2013
The following customer information must be provided to customers
with each product.
The statements provided below should be conspicuously located in
the end user system documentation:
This product is listed by Underwriters Laboratories, a Nationally
Recognized Test Laboratory (NRTL). The Listing Mark is located on
the bottom surface of the board. The Dialogic® Brooktrout® board
has been tested and complies with UL 60950 and CAN/CSA-C22.2
No. 60950, Safety of Information Technology Equipment, Including
Electrical Business Equipment.
Install this card only in UL Listed equipment that has instructions
stating that the user may install and remove accessory cards.
This product must be mounted in the final assembly so that it is
isolated from exposure to any hazardous voltages (voltages greater
than 42.4V peak or 60Vdc) within the assembly. Adequate
separation and restraint of cables and cords must be provided.
To maintain the safety certification of the system, ensure that the
power drawn from the power supply does not exceed its capacity.
Please refer to the power usage table on the hardware installation
card applicable to your board for information on the voltages and
currents required for proper operation.
Models of this card that contain DID interfaces are for use only in
equipment that has a permanent connection to protective earth and
is installed in a restricted access location.
Safety Compliance Statements
179