Running The Dialogic® Brooktrout® Configuration Tool - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Running the Dialogic® Brooktrout® Configuration
Tool
March 2013
You can run the Brooktrout Configuration Tool from:
The program menu:
→
Start All Program
Configuration Tool
The command line:
C:\Brooktrout\Boston\utils\winnt\bin\configtool.exe
To specify the mode on the command line, use one of the
following:
/a – Advanced Mode
/o – Offline Mode
/s – Silent Mode
/t – Timer Mode
/w – Wizard Mode
Other command line arguments include:
/c (configip)
Displays the following note:
Note: /c option brings up the Configure IP Stack dialog box
only if there are IP enabled devices installed.
/d (debug)
Enable the debug flag, which initiates writing of the debug
information to the configuration.log file.
/e (expert)
Show all hidden parameters. Use this mode only under the
guidance of Dialogic Technical Services and Support
personnel. See
/i <INF file location>
Use the specified INF file to install the PnP driver when it is
not installed or installed but not started.
You must uninstall any previous version of the plug and play
driver INF file. See
page 99 or Removing the Driver with a Command (cmd)
Prompt on page
Running the Dialogic® Brooktrout® Configuration Tool
→
Brooktrout
Getting Technical Support on page
Removing the Plug-and-Play Driver on
107.
→
Brooktrout
22.
124