Quick Start For Linux And Solaris Systems; Step 1: Install Dialogic® Brooktrout® Software And Hardware - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Quick Start for Linux and Solaris Systems

Step 1: Install Dialogic® Brooktrout® software and
hardware
March 2013
The Brooktout SR140 Software is not supported on the Solaris
operating systems.
Follow the steps below to install Dialogic® Brooktrout®
software and hardware:
1. Power down the computer and install the Dialogic® Brooktrout®
board in your computer chassis. For installation instructions, see
the hardware installation card that came with your board.
2. Power up the computer and log on.
When the status LED on the board is flashing yellow, it is
ready to have the firmware downloaded. See
Configure the Dialogic® Brooktrout® Software and
Hardware on page
Insert the Dialogic® Brooktrout® Fax Products SDK CD-
ROM into a CD-ROM drive. Then refer to
on Red Hat Linux on page 34
Solaris on page
This procedure places the contents of the CD into a directory
on your hard drive. The directory can be one you specify or
the default, /usr/sys/brooktrout/boston. See
Structure on page 144
contents in the /boston directory structure.
3. Start the driver. Linux and Solaris, if you want, can start the
driver, but you can wait until the software is installed before you
start the driver. See the appropriate chapter that applies to your
operating system.
Quick Start for Linux and Solaris Systems
29.
or Installing the SDK on
54.
for the list of directories and their
Step 2:
Installing the SDK
Directory
31