Installation Steps - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Installation Steps

March 2013
To install the software on Solaris, follow the steps below. When
running driver installation programs, scripts, or functions, you must
be logged in as root or have administrative privileges.
The software is for SPARC®. Dialogic supports only official
development environments from Sun, such as Sun Workshop, Sun
Pro, and Forte. In particular, GNU development environments are
not supported.
Note: The SR140 is not supported on Solaris operating systems.
To install hardware and software, use the following steps:
1. Install the firmware, driver, and Bfv API software onto your
computer.
If you are reinstalling or upgrading the software, you must first
remove the previously installed software before installing this
software.
See Removing the Software on page
2. Compile the sample applications and utilities (optional).
See in the Dialogic® Brooktrout® Fax Products SDK Developer
Guide the chapter on compiling the sample applications.
3. Run the dinstall program to configure the driver (optional).
See Configuring the Driver Manually on page
4. Download the firmware and configure the call control
parameters, see:
Downloading Firmware on page 159
Using a Call Control Configuration File on page 142
Installation Steps
58.
60.
55