Configuring In Wizard Mode - Dialogic Brooktrout TruFax TR1034 User Manual

Configuring in Wizard Mode

March 2013
This section describes how to use the Wizard Mode to configure
Dialogic® Brooktrout® Fax Software. You can use Wizard Mode to
get most typical systems up and running with minimal effort.
In Wizard Mode, after you answer the basic questions, the
Configuration Tool does the following.
Automatically creates the necessary configuration file
Installs and starts the drivers, if required
Starts the Boston Host Service
Wizard Mode requires that all the modules be of the same kind. All
modules are configured identically, that is, the modifications to the
configuration apply uniformly to all the modules.
You can use Wizard Mode in a homogeneous configuration where:
all the boards are of an identical type
or
the system contains only SR140 virtual boards.
In a non-homogeneous configuration, the Configuration Tool will
automatically start in Advanced Mode.
To use Wizard Mode:
1. Start the Configuration Tool if it has not already been started by
the Plug-and-Play installation procedure. See
Default Configuration on page
Configuring in Wizard Mode
Returning to the
127.
66