Dialogic Brooktrout Digital Board Installation And Configuration Manual page 104

March 2013
Installing and Configuring the Driver using a Command (cmd) Prompt
Configuring Boston driver:
Phys buf size 32768
App buffer size 10240
Machine ID 1
History size 1024000
Num phys hist bufs 0
Num apl hist bufs 0
Load driver with no devices present? (y or n, default y):
When using Boston PCI hardware modules, a system memory
adjustment may be required in order to properly access the
modules. For a small number of modules this is often not
required, but many factors, including other devices that
are or will be in the system, affect this. After this
adjustment is made, the system must be rebooted.
Do you wish to perform this adjustment? (default n):
After installing the Plug-and-Play driver, the following message
appears:
Installing Plug and Play driver.
The Plug and Play driver was successfully installed.
The maximum number of PCI hardware modules can be left at its
default. However, if fewer modules are in use, this value can be set
to a smaller number to conserve memory. Each hardware module
uses approximately 60K.
The following exit codes from the install program, either for driver
installation or removal, can be used to determine if there was an
error and/or if a reboot is required.
0 - No error and no reboot required
1 - No error and reboot required
-1 - Error and no reboot required
-2 - Error and reboot required
For more information, see:
Command Line Configuration for Install on page 114
Windows Operating System on page 190
104