Disabling Plug-And-Play Driver Installation; Reinitializing The Driver - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Disabling Plug-and-Play Driver Installation

Reinitializing the Driver

March 2013
After you install a Dialogic® Brooktrout® board, the Windows
operating system might display a window stating that a new PCI
device was found and offer to detect/install a driver for it. Proceed
with the automatic detection. The operating system will not find a
matching driver. Do not attempt to supply a driver when asked.
The detection of new hardware occurs after each reboot
unless you perform the following procedure:
1. When Welcome to Found New Hardware Wizard appears, click
Next.
2. Select Search for a suitable driver for my device (recommended).
3. Click Next, uncheck all choices, then click Next again.
4. Select Disable device
5. Click Finish.
Another approach is to:
1. Click Cancel for ALL new devices that are found.
2. Right-click My Computer .
3. Right-click Properties.
4. Right-click Hardware
5. Right-click Device Manager.
6. Look for:? Other Devices.
7. Right-click all devices with:?.
8. Select Disable.
You can reinitialize the driver to its starting state in terms of
channels assigned to modules and module number assignments
using the driver_reinit.exe utility located in the
boston\driver\winnt\user directory (see
Driver on page 196).
Installing the Plug-and-Play Driver
Reinitializing the Device
102