Dialogic Brooktrout Digital Board Installation And Configuration Manual page 37

March 2013
The program then displays:
Press ENTER to continue or 'q' then ENTER to quit
setup.
4. The program then displays:
Default install directory is /usr/sys/brooktrout
Please enter desired install directory or just press
ENTER to use default directory.
5. After you enter an install directory or accept the default directory
location, the program prompts you to identify files to install:
1) Boston API/Driver Package.
2) Firmware Package.
3) Boston API/Driver and Firmware Packages.
0) Exit Installation.
Please enter the number corresponding to the files you
wish to install?
6. Type the number of your choice.
If the packages you selected have been installed, the program
gives you as message to that effect, such as:
The Boston API/Driver Package was installed
previously.
Otherwise, the program gives you a message such as:
Running RPM to install the Boston API/Driver Package
7. Please read and accept the license agreement to continue:
Press the spacebar to continue or q to quit. (The program named
"less" displays the license agreement.)
8. After you choose q to quit out of license agreement you get the
following message:
Do you accept the above agreement?
9. If you choose y or yes, your files will install correctly.
If you choose any other character the installation script will
terminate with an error.
10. The program then asks:
Would you like to configure the driver at this time
[y or n]?
If you choose Boston API/Driver and Firmware Packages and the
default directory, the directory /usr/sys/Brooktrout contains the
directories and files shown in Directory Structure on page
Installation Steps
144.
37