Starting Or Stopping The Driver; Reinitializing The Driver - Dialogic Brooktrout Digital Board Installation And Configuration Manual

Starting or Stopping the Driver

Reinitializing the Driver

March 2013
This command removes only the files and directories that the
installation procedure placed on the system.
Because the driver loads automatically when needed, there are no
explicit steps required to load the driver.
To stop or shut down the driver, enter:
/etc/bostunld -r
You can reinitialize the driver to its starting state in terms of
channels assigned to modules and module number assignments
using the driver_reinit utility located in the
boston/driver/solaris/user directory (see
Driver on page 196).
Installation Steps
Reinitializing the Device
59