Programmed Shut-Off (Weekly Timer) - Konica Minolta 7022 Instruction Manual

Programmed Shut-Off (Weekly Timer)

The Weekly Timer function turns a copier on and off at the time specified by the Key
Operator.
This function is not factory-set. When a copier is under control of the Weekly Timer
function, the Timer Interrupt mode message will be displayed after pressing the power
switch, and copying is unavailable.
However, copying can be available by using the following procedure.
1.
Press the power switch.
For details of the Weekly Timer function, see p. 11-31 to p. 11-39.
The Basic screen will be displayed along with the message shown below.
Timer interrupt mode
Enter password
The machine power will be turned off automatically after 5 minutes from this
state if a password is not entered.
The Timer Interrupt password is not factory set and must be entered by the Key Oper-
ator.
In the event the Timer Interrupt password has not been entered by the Key Operator,
the following message will display instead.
Input copy time
0 hour(s)
When the above message displays, proceed to step 4.
2.
Enter the password.
Enter a 4-digit number Timer Interrupt password using the keypad on the control
panel.
For setting the Timer Interrupt password, see p. 11-39.
If an invalid password is entered, continue by entering the valid 4-digit
password.
7-2
HINT
DETAILS
05 minute(s)
HINT
DETAILS