Selecting Paper Size; S Electing Paper Size; To Select Paper Size Automatically (Aps) - Konica Minolta 7022 Instruction Manual

Selecting Paper Size

To select an appropriate paper size for getting your desired copy result, use APS
(Automatic Paper Selection), or select paper size manually on the touch screen, as
required.

To Select Paper Size Automatically (APS)

APS detects the size of originals placed on the RADF or platen glass and automatically
selects and feeds copy paper of the same size, or selects an appropriate size according
to the magnification ratio selected.
• See the table on the following page for the relation of original size,
• The initial settings may have been altered by Key Operator. See p. 11-7 to
1.
Touch to highlight APS at lower right corner of the Basic Screen.
APS is already highlighted when the initial settings are restored.
2.
Select additional copy conditions, as desired.
3.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
4.
Position original(s).
• See p. 9-6 to p. 9-8 for paper sizes detectable from the RADF or on the
• See p. 3-2 to p. 3-6 for details on positioning originals.
• Key Operator can deactivate APS when original is set in the RADF or on
5.
Press [START].
• If the appropriate copy paper is not loaded in any tray, no copying will be
• Copy result may not be satisfactory due to the Rotation function. In this
3-8
HINTS
magnification ratio and copy paper size.
p. 11-14.
HINT
HINTS
platen glass.
the platen glass. See p. 11-42 to p. 11-45.
DETAILS
performed, and a message will prompt you to load the appropriate paper.
case, turn the function OFF manually. See. p. 7-4.