Output Modes - Konica Minolta 7022 Instruction Manual

4.
Touch OK to return to the Basic Screen.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original(s).
Using platen glass:
Place original FACE DOWN. Start scanning from the first page.
When Dual Page, Non-Image Area Erase, Auto detection mode of Repeat,
or AUTO Layout is selected, keep the RADF open throughout the scanning
procedure.
Using RADF:
Position originals FACE UP.
If the number of originals exceeds 50, divide them into blocks not exceeding 50 sheets
and load them from the block with the first page.
See p. 3-2 to p. 3-6 for details on positioning originals.
7.
Touch SCAN on the Basic Screen to scan.
Repeat steps 6 and 7 until all originals are scanned.
Memory indicator on the upper right of the Basic Screen allows you to check
the remaining memory.
To delete the scanned data without printing, press [STOP/CLEAR].
Should memory overflow occur frequently, it is recommended that you
contact your service representative to extend the memory capacity in your
machine.
8.
Press [START] to print.
All the data in memory will be output.
Press [STOP/CLEAR] to suspend the printing job.
Copying Using Memory (continued)
HINT
Reminder!
HINT
DETAILS
HINT
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Paper Size
Lens Mode
Density
1-1, 2-2
2-1
Using
Memory
Output without
Finisher
FS-107

Output Modes

IT-101
Output Modes
Check Mode
& Proof Copy
Interrupt
Mode
3-23