Error Messages - Genicom LN28 User Giude

Error Messages

The table below lists error messages, the possible causes of each error, and the actions required to
recover from each error.
Error Message
Line 1
E0 JAM HCF
E1 JAM TRAY/REGI
E2-1 JAM MISFEED
E2-2 MISFEED DUP
E3 JAM REGI/FUSR
E4 EXIT JAM
E7 JAM DUPLEX
E8 JAM OFF. TRAY
E5 TRAY OUT
E5 COVER OPEN
E5 COVER OPEN
E5 COVER OPEN
J3 TONER CART.
LOAD PAPER TRAY1
LOAD PAPER TRAY2
LOAD PAPER TRAY3
LOAD PAPER FRONT
OUTPUT TRAY FULL
OFFSET TRAY FULL
Nov 00
GENICOM LN28 and microLaser 280 User Guide 5-41
Error Message Possible Cause
Line 2
Remove Paper There is a paper jam
inside the printer.
Reposition Front The front tray is out.
Top/Rear The top cover or rear
cover is open.
Offset Tray The offset tray cover is
open.
Close HCF Cover The HCF cover is open.
Install/Reset The toner cartridge is
not installed, or an
incorrect cartridge is
installed.
Paper Size/ Tray 1 is empty.
Paper Type
Paper Size/ Tray 2 is empty.
Paper Type
Paper Size/ Tray 3 is empty.
Paper Type
Paper Size/ The front tray is empty.
Paper Type
Remove Paper The output tray is full.
Remove Paper The offset output tray is
full.
Genicom
Warning Messages and Error Messages
Action
Remove the jammed paper from
the indicated location.
See the "Paper Jams" on page
5-4 for information about
removing paper jams.
Reposition or close the front tray.
Close the top or rear cover.
Close the offset tray cover.
Close the HCF cover.
Install the correct toner cartridge
according to the specifications.
See "Replacing the Toner
Cartridge" on page 4-3.
Load paper into the tray.
Load paper into the tray.
Load paper into the tray.
Load paper into the tray.
Remove paper from the tray.
Remove paper from the tray.
Publication No. GEG-99018A