Testing the Duplexer
After installing the duplexer, use the following procedure to make sure it transports paper correctly:
1.
Turn the printer on by pressing the [ I ] on the power switch on the right side of the printer.
2.
Once the printer has warmed up and displays the "Ready" message on the control panel dis-
play, use any software application to print a few duplexed sheets.
3.
If the duplexer does not transport paper or if the control panel shows an error message, refer
to "Solving Duplexer Problems" on page 6-6.
Nov 00
GENICOM LN28 and microLaser 280 User Guide 6-5
7
8
Genicom
Testing the Duplexer
Publication No. GEG-99018A