Table of Contents
Advertisement
Maintaining the High Capacity Feeder
The high capacity feeder requires very little maintenance; however, with normal use you will need
to perform some routine maintenance tasks such as cleaning the high capacity feeder and replacing
certain components.
Cleaning the Interior of the High Capacity Feeder
Generally, the interior of the high capacity feeder seldom needs cleaning unless paper dust accumu-
lation inside the high capacity feeder starts to cause recurring paper feed problems.
Since there is always the possibility of damaging delicate high capacity feeder components
by carelessness or by overly vigorous cleaning methods, we recommend that you clean the
interior only when you are instructed to do so by a service representative or by a procedure
presented in this manual.
1.
Turn the printer off by pressing the [ O] on the power switch on the right side of the printer.
2.
Remove the plug of the AC power cord from the AC wall outlet.
3.
Remove all paper from the high capacity feeder drawer.
4.
Remove the paper drawer from the high capacity feeder by sliding the drawer out of the high
capacity feeder and then raising the front of the tray to disengage it from the rails. Slide the
drawer completely out of the high capacity feeder.
5.
For minor cleaning, use a soft, dry cloth and carefully wipe only those areas of the high capac-
ity feeder interior that appear to be dirty.
For major cleaning, use a small vacuum cleaner with a disposable bag and crevice tool attach-
ment. Use a soft-haired brush to dislodge dirt and sweep it into the vacuum nozzle.
6.
Reload paper into the high capacity feeder drawer.
7.
Raise the front of the high capacity feeder drawer while you slip the rear of the drawer into
the rails on the sides of the high capacity feeder, then slide the drawer back into the high
capacity feeder.
8.
Insert the plug of the AC power cord into the AC wall outlet, and turn the printer on by
pressing [ I ] on the power switch on the right side of the printer.
Cleaning the Exterior of the High Capacity Feeder
Through normal use the exterior of the high capacity feeder may become dirty or stained with
toner. Although exterior dirt should not affect printer performance, an occasional exterior cleaning
may be necessary to maintain the appearance of the high capacity feeder.
1.
Turn the printer off by pressing [ O ] on the power switch on the right side of the printer.
2.
Remove the plug of the AC power cord from the AC wall outlet.
Nov 00
GENICOM LN28 and microLaser 280 User Guide 8-19
Maintaining the High Capacity Feeder
Genicom
Publication No. GEG-99018A
Advertisement
Table of Contents
