Table of Contents
Advertisement
9-8
GENICOM LN28 and microLaser 280 User Guide
Testing the Offset Output Tray
13.
Attach the paper guide near the paper exit slot.
14.
Insert the plug of the power cord into the AC outlet and turn the printer on by pressing
[ I ] on the power switch on the right side of the printer.
15.
Check the display to make sure the printer is ready for printing.
NOTE:
If an error message is shown when you turn the printer on, refer to Chapter 5:
Troubleshooting.i
Testing the Offset Output Tray
After installing the offset output tray, use the following test procedure to verify that it is operating
correctly.
1.
Turn the printer on by pressing the [ I ] on the power switch on the right side of the printer.
2.
Once the printer has warmed up and displays the "Ready" message on the control panel dis-
play, use any software application to print a few sheets to the offset output tray.
3.
If the feeder does not feed paper or if the control panel displays an error message, refer
to"Solving Offset Output Tray Problems" on page 9-8.
Solving Offset Output Tray Problems
When there is a problem with the offset output tray, the printer control panel displays an error code
and error message. Most offset output tray error codes indicate routine status conditions such as a
paper jam. Some error codes indicate much more serious problems that may require the help of a
service technician.
•
If the offset output tray is inoperative after installation, refer to "Installation Problems" on
page 9-9 and complete the recommended procedure.
•
If the printer control panel displays an error message or an error code, refer to "Interpreting
Offset Output Tray Error Messages" on page 9-9.
•
If you have an offset output tray problem but the printer control panel does not display an
error message or error code, refer to "Correcting Miscellaneous Offset Output Tray Prob-
lems" on page 9-11s and follow the directions for correcting that problem.
Publication No. GEG-99018A
Genicom
Nov 00
Advertisement
Table of Contents
