Warning Messages - Genicom LN28 User Giude

5-40 GENICOM LN28 and microLaser 280 User Guide
Warning Messages and Error Messages

Warning Messages

The following table lists warning messages, possible causes, and the actions required to correct each
cause.
Warning Message
Line 2 of display
Tray 1 Missing
Tray 2 Missing
Tray 3 Missing
Paper Low Tray 1
Paper Low Tray 2
Paper Low Tray 3
Paper Out Tray 1
Paper Out Tray 2
Paper Out Tray 3
Output Tray Full
Offset Tray Full
HCF Lifting
Maintenance Req
Publication No. GEG-99018A
Possible Cause
Tray 1 is not installed.
Tray 2 is not installed.
Tray 3 is not installed.
The paper supply in tray 1 is low.
The paper supply in Tray 2 is low.
The paper supply in Tray 3 is low.
There is no paper in Tray 1.
There is no paper in Tray 2.
There is no paper in tray 3.
The output tray is full.
The offset output tray is full.
The HCF is lifting.
Maintenance is required.
Genicom
Action
Install the tray.
Install the tray.
Install the tray.
Add paper to the tray.
See "Loading the Main Tray" on
page 2-12.
Add paper to the tray.
Add paper to the tray.
Add paper to the tray.
Add paper to the tray.
Add paper to the tray.
Remove paper from the tray.
Remove paper from the tray.
Wait until the HCF has finished
lifting completely.
Call service.
Nov 00