Maintenance Instructions; Helpful Hints; Tool List; Maintenance Records - Stairmaster MOMENTUM C40 Owner's Manual

MAINTENANCE INSTRUCTIONS

HELPFUL HINTS

If you keep your StairMaster
serviced and in good condition, it will operate more efficiently and last longer. It
is strongly recommended that you adhere to the maintenance service guidelines
presented in this Owner's Manual. Read all maintenance instructions thoroughly
before beginning work. In some instances, the use of an assistant is recom-
mended to perform the necessary task efficiently. Upon receiving your new
Momentum systems cycle ergometer, use a soft, clean towel to wipe off the dust
that may have accumulated during shipping. Your new machine will require minor
assembly. Refer to the "Installation Instructions" section of this manual for
details. All references to the right or the left side and to the front or the back of
the Momentum systems cycle ergometer are made as if you were sitting on the
machine ready to exercise.

TOOL LIST

The following tools are needed to perform service and maintenance on the
Momentum systems cycle ergometer:
• shop goggles or other eye protection
• locking pliers
• snap ring pliers, external snap rings
• combination wrenches (sizes 7/16" to 3/4")
• adjustable wrench
• 2-mm cone wrench
• allen wrenches (T-handled and L-bend)
• socket set or nut driver set (sizes 1/4" to 3/4")

MAINTENANCE RECORDS

The console on the Momentum systems cycle ergometer will keep track of
important usage data on the machine. While the console displays "SELECT
WORKOUT", enter the following codes to retrieve usage data:
• [ ^ ] [ 4 ] [ 0 ] Machine run time in hours
NOTE: The console may display several hours of use when your
Page 34
®
Momentum systems cycle ergometer properly
• standard screwdriver
• volt-ohm meter
• phillips screwdriver
• adjustable pliers
• alligator clips
• 15-mm cone wrench