Error Messages - Stairmaster MOMENTUM C40 Owner's Manual

2.

Error Messages

Text line messages are only seen in the Constant Heart Rate and Fitness Test
programs due to the design of the program that necessitates a valid heart rate
signal during the program. For these programs, ensure that neither the "BOTH HR
OFF" or the "HAND ONLY" option is set as a default option.
" CHECK HR BELT " - The heart rate signal has been missing for the last 30
seconds in telemetry signal detection.
"HR BELT NEEDED" - No telemetry belt signal has been sensed during the
initial setup time.
There are four options to handle heart rate input signals.
Press the [SELECT] key to scroll through the options until you
find the one option that suits your needs. Press the [ENTER]
key to select that option.
" BOTH LOCKED " - allows either telemetry or contact heart
rate signals to be detected. Once the console has detected a
valid input signal it will lock out the opposite type of signal for
the duration of the workout session. For example, if you start
out using contact heart rate then you are limited to using only
contact heart rate during your workout session, even if the
signal is lost while performing the workout, and vice-versa.
" EITHER INPUT " - allows either telemetry or contact
heart rate signals to be detected. Does not lock out a particular
input signal for the entire workout. This option will detect
either input signal during a workout session, but only one at a
time, and only until the other signal terminates.
" TELEMETRY ONLY " - locks out contact heart rate signals
and will only detect telemetry signals.
" HAND ONLY " - locks out telemetry signals and will only
detect contact heart rate signals.
" BOTH HR OFF " - turns off the ability to detect any signal at
all. Used in rare situations where there is excessive interfer-
ence with the heart rate signals. *This option disables the
Constant HR program and the Fitness Test program.
HEART RATE MONITORING
Page 13