Console; Handlebar Assembly (3400 Ce) - Stairmaster MOMENTUM C40 Owner's Manual

PARTS REMOVAL AND REPLACEMENT
4. Move the crank to about the eleven o'clock position on the left side
to get the left side cover over the crank and off the machine. Once the
left cover is off the frame, move the cranks to the one o'clock position
on the right side and remove the right cover.
5. To reinstall the cover fasteners, insert the fastener base through the
cover and into the frame. When the base is in place, push the head
pin in all the way to secure the fastener. If necessary, connect the
battery charger to the power connector once the side covers are
attached.

CONSOLE

1. Unscrew the four console mounting knobs from the back of the console.
2. Gently lift the console up a few inches and disconnect the main cable
and contact heart rate cables from the back of the console. Remove the
console from the machine.
3. Reverse the steps to reinstall the console.

HANDLEBAR ASSEMBLY (3400 CE)

1. Remove the console.
2. Tilt the machine back and rest it on its seat, upside down. The handle
bars should now be in the air and allow easy access to the mounting
screws and the main cable.
3. Gently pull the main cable out from the frame tube. The main cable is
sectioned into two parts with quick release connectors attached.
Disconnect each section of main cable to allow removal of handlebars.
4. Loosen and remove the four screws and flat washers from the main
frame.
5. Hold onto the handlebars and pull the handlebar assembly out from the
main frame.
Page 50