Maintenance Instructions; Helpful Hints; Tool List; Maintenance Records - Stairmaster StepMill 7000 Owner's Manual

HELPFUL HINTS

Read all maintenance instructions thoroughly before beginning work. In some
cases, an assistant is required to perform the necessary tasks. The safety level
given by the design of this equipment can only be maintained when the equip-
ment is regularly examined for damage and wear. Inoperable components shall
be replaced immediately or the equipment shall be put out of use until it is
repaired. All references to the right or left side and to the front or back are made
as if you were on the machine ready to exercise.

TOOL LIST

The following tools are needed to perform service and maintenance:
• Standard screwdriver
• Combination wrenches (sizes 7/16 - 3/4") • Adjustable wrench
• Combination pliers
• Shop goggles or other eye protection
• Allen wrench set (sizes 5/64 - 1/4")
• Socket set or nut driver set
(sizes 1/4 - 3/4" in 1/16" increments)

MAINTENANCE RECORDS

For ease of maintenance the 4400/4600 PT/CL console will keep track of hours,
number of workouts, time between last servicing, etc. You can quickly access any
of the custom menus by pressing [LEVEL: ^], [4], [ENTER]. The console will then
display "MACHINE STATUS". Scroll through the following options:
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
[ SELECT ]
*The machine may show a few hours of use due to testing at the
manufacturing facility.

MAINTENANCE INSTRUCTIONS

" RUN HOURS
" WORKOUTS
" DISTANCE
" CONS 90211- XXX "
" STEPMILL"
-N/A-
" MAINT HOURS xxxx"
• Phillips screwdriver
• External snap ring pliers
• Wire stripper/crimper tool
• Volt-ohm meter (multimeter)
• Locking pliers
XXXX"* 0
XXXX" 1
XXXX" 2
3
4
6
Page 31