MAINTENANCE INSTRUCTIONS
HELPFUL HINTS
Read all maintenance instructions thoroughly before beginning work. In some
cases, an assistant is required to perform the necessary tasks. The safety
level given by the design of this equipment can only be maintained when
the equipment is regularly examined for damage and wear. Inoperable compo-
nents shall be replaced immediately or the equipment shall be put out of use
until it is repaired.
All references to the right or left side and to the front or back are made as if
you were on the machine ready to exercise. For example, the power supply is
plugged into the connector near the bottom of the right side cover.
TOOL LIST
The following tools are needed to perform service and maintenance:
• Standard screwdriver
• Combination wrenches (sizes 7/16 - 3/4") • Adjustable wrench
• Combination pliers
• Shop goggles or other eye protection
• Allen wrench set (sizes 5/64 - 1/4")
• Socket set or nut driver set
(sizes 1/4 - 3/4" in 1/16" increments)
MAINTENANCE RECORDS
The console will keep track of the following data on machine usage:
• The number of hours the power supply was turned on.
• The number of hours the machine was in use.
• The total number of floors climbed.
• The number of exercise programs started.
• The hours of MANUAL use.
To display the data, press [+ INCREASE], [7], [7], [0], [3], [ENTER] while the
console is in the ATTRACT mode. The console will display the data in the
sequence listed above. The machine may show a few hours of use due to testing
at the manufacturing facility.
Page 22
• Phillips screwdriver
• External snap ring pliers
• Wire stripper/crimper tool
• Volt-ohm meter (multimeter)
• Locking pliers