Maintenance Instructions; Helpful Hints; Tool List; Maintenance Records - Stairmaster FreeClimber 4600 PT Owner's Manual

MAINTENANCE INSTRUCTIONS

HELPFUL HINTS

Read all maintenance instructions thoroughly before beginning work. In some
cases, an assistant is required to perform the necessary tasks.
All references to the right or left side and to the front or back are
made as if you were on the machine ready to exercise. For example, the console
is located on the front of the machine. Major component names and locations
are shown in Figure 10. When ordering parts, reference the part number in
parentheses next to the part's description on the figures.

TOOL LIST

The following tools are needed to perform service and maintenance:
• standard screwdriver
• combination wrenches (sizes 7/16 - 3/4") • adjustable wrench
• combination pliers
• volt-ohm meter (multimeter)
• allen wrench set (sizes 5/64 - 1/4")
• shop goggles or other eye protection
• socket set or nut driver set (sizes 1/4 - 3/4" in 1/16" increments)

MAINTENANCE RECORDS

The 4600/4400 PT/CL console will keep track of the following data on
machine usage:
• The number of hours the power supply was turned on.
• The number of hours the machine was in use.
• The total number of floors climbed.
• The number of exercise programs started.
• The hours of MANUAL use.
To display the data, press [+ INCREASE], [7], [7], [0], [3], [ENTER] while
the console is in the ATTRACT mode. The console will display the data in the
sequence listed above. The machine may show a few hours of use due to testing
at the manufacturing facility.
Page 32
• phillips screwdriver
• locking pliers
• wire stripper/crimper tool
• external snap ring pliers
• torque wrench