Network Interface Board Installation
The standard interface for the Falcon Outdoor printer has a parallel Centronics
compatible interface as standard equipment. The network interface board, RJ-
ETH14TX, for connection to EtherNet is also available as an option.
The following procedure explains how to install the network interface board.
CAUTION
• The power to the Falcon Outdoor must be switched off and the
power cord removed before the network interface board is
installed.
Step 1
Undo the screws holding the silver colored interface plate on the left side of
the board box below the printer and remove the interface plate.
Interface Plate
Step 2
Insert the optional interface board into the slot as shown in the diagram. When
the interface board has reached the back, push it again to ensure it is pushed
fully back.
Interface Board
166
Falcon Outdoor 46/62 USER GUIDE (AP-75046)
Board Box