Nothing Happens After The Computer Sends Data; Parts Of The Print Are Dirty Or Missing - MUTOH Falcon Outdoor 46 User Manual

#Nothing happens after the computer sends data

Possible Cause
(1) Is the interface cable con-
nected?
(2) Are ink cartridges
installed?
(3) Do they contain ink?
(4) Have you replaced the
waste bottle?
#When printer sends data, the printer shows and error and
does not print
Possible Cause
(1) Does the computer have
the proper type of equip-
ment selected?
(2) Do interface conditions
and command modes
match on both computer
and printer?

#Parts of the print are dirty or missing

NOTE
• If the media is not media specified by Mutoh, you may be
unable to obtain proper printing quality.
Possible Cause
(1) Is the media damp?
(2) Are you using creased or
wrinkled media?
Falcon Outdoor 46/62 USER GUIDE (AP-75046)
92
When Trouble Strikes
Remedy
Refer to "Connecting the inter-
face cable".
Install ink cartridges.
Replace ink cartridges.
Replace waste bottle.
Remedy
Check that the equipment type
settings are the same on both
the computer and printer.
(Refer to "To receive data from
the computer".
Remedy
Replace with new media.
Reference
Page
Page 67
Page 40
Page 191
Page 198
Reference
Page
Page 68
Reference
Page
Page 48
203