Understanding The Functions; Command Settings - MUTOH Falcon Outdoor 46 User Manual

Understanding the Functions

Command Settings

Command
This specifies the commands and conditions that are trans-
ferred from the computer. The following commands are sup-
ported:
• RTL-PASS:
• MH-GL, GL2 (MH-RTL): Mutoh MH-GL/MH-GL/2 (MH-RTL)
• MH-GL2 (MH-RTL):
(MH-GL, GL2 printing unit is 0.025 mm)
Plot Area
This specifies environmental functions for the printer. It speci-
fies the printing area (hardclip area) for the media size.
• Normal: Specifies the standard printing area for
Falcon Outdoor printers
Distance from edges of media:
Cut sheet - Front 25 mm, Back 20 mm, Sides 10 mm
Roll media - Front 25 mm, Back 20 mm, Sides 10 mm
• Expanded: Specifies a printing range for the Falcon Outdoor
printer that is interchangeable with Mutoh XP
Series pen plotters.
However, since the maximum printing range is 1554.8 mm for
a 62-inch printer, if expanded mode is specified with media
wider than 1564.8 mm for a 62-inch printer, the left and right
margin shown below will be differed.
Distance from edges of media:
Cut sheet - Front 25 mm, Back 20 mm, Sides 5 mm
Roll media - Front 25 mm, Back 20 mm, Sides 5 mm
(media width 62 inch: 1564.8 mm or less)
100
Name of Function
commands (conform to Hewlett-
Packard HP-GL, HP-GL/2 (HP-RTL)
commands)
Mutoh MH-GL/2 (MH-RTL) commands
(conform to Hewlett-Packard HP-GL/2
(HP-RTL) commands)
Falcon Outdoor 46/62 USER GUIDE (AP-75046)
Reference
Page
Page 113
Page 114