Memory Extension - MUTOH Falcon Outdoor 46 User Manual

Memory Extension

Standard internal memory for the Falcon Outdoor printer is 8 MB + 32 MB (slot
1) but this can be extended by fitting an additional 16 MB (SIM16M) or 32 MB
(SIM32M) memory chips (sold separately).
The following procedure explains how to install extended memory.
CAUTION
• The power to the printer must be switched off and the power
cord removed before the additional memory is installed.
Step 1
Remove roll media and scroller from
the printer. Undo the three screws hold-
ing the board box on the printer main
unit and carefully lower the board box.
Remove two thumb screws to reveal
the memory slot.
CAUTION
• Electronic components are susceptible to damage by static
electricity. Remove static charge from your clothes and body
by touching your hands to the board box before you touch the
additional memory chip.
• Dust in the slot may cause damage. Blow it out with an air
duster before installing the additional memory.
Step 2
The optional memory chip to be added should be inserted in slot 2 on the
lower right of the board with the nicked end of the chip at the right hand end of
the slot.
168
Board Box Fastening Screws
Falcon Outdoor 46/62 USER GUIDE (AP-75046)