Configure Management - Paradyne BitStorm 4800 User Manual

A. CLI Command Descriptions

Configure Management

The configure management command sets parameters for remote management
of the BitStorm 4800.
Table A-12. Configure Management Command (1 of 9)
A-24
configure management address
{bootp | {{ ip_address } { subnet_mask } { default_gateway }}}
Minimum Access Level: Administrator
The configure management address command specifies the IP address of the
BitStorm 4800, or specifies that it will be assigned using BOOTP (Bootstrap Protocol).
bootp – Specifies that a BOOTP server will determine the management IP address.
Management addresses are cleared in anticipation of a BOOTP response.
ip_address – Specifies the management IP address. The default address is 10.10.10.10.
subnet_mask – Specifies the subnet mask to be applied to the IP address. The default
mask is 255.255.255.0.
default_gateway – Specifies the management next hop or gateway IP address. The
default gateway is 10.10.10.254.
Examples:
IAC#configure management address bootp
IAC#configure management address 137.90.127.3 255.255.255.0
137.90.127.1
configure management ipsec {disable | enable}
Minimum Access Level: Administrator
The configure management ipsec command determines whether management traffic is
subject to IPsec.
disable – Specifies that IPsec is not used. IPsec parameters may be set while in this
state, but they have no effect until IPsec is enabled. This is the default.
enable – Specifies that IPsec is used to implement a Virtual Private Network (VPN).
Example:
IAC#configure management ipsec enable
July 2002 4800-A2-GB20-10