Configure Date - Paradyne BitStorm 4800 User Manual

A. CLI Command Descriptions

Configure Date

The configure date command sets the date, time, and time zone in the
BitStorm 4800.
When it is first powered on, the unit attempts to obtain the date and time from an
NTP server on the Internet. If it fails, the unit's date is set to January 1, 2001, and
the time is set to 00:00:00.
Table A-5. Configure Date Command
A-6
configure date [ mm/dd/yy | dd/mm/yy ] [ hh:mm ]
Minimum Access Level: Administrator
The configure date command sets the date and time.
mm/dd/yy or dd/mm/yy – specifies the month, day, and year, each as two digits. The
date format is set by the configure system options command (see
Configure System Options Command); the default order is month, day, and year.
hh:mm – Specifies the time in hours (0–23) and minutes (0–59).
Example:
IAC#configure date 03/21/02 13:05
configure date-timezone { time_zone }
Minimum Access Level: Administrator
The configure date-timezone command specifies the time zone the date and time are
relative to.
time_zone – Specifies the offset in hours from Greenwich Mean Time (GMT) that the date
and time represent. Hours before GMT are expressed as negative numbers and hours
after GMT are expressed as positive numbers (with or without a plus sign). Half hours are
supported as decimals. Valid values are –12 through 12.
Offsets are listed in Table F-1, Time Zone Names,
can also obtain a list of time zone offsets using the command:
configure date-timezone ?
The unit does not adjust for Daylight Savings Time.
Examples:
IAC#configure date-timezone +2
IAC#configure date-timezone 9
IAC#configure date-timezone -3.5
July 2002
Table A-18,
in Appendix F, Reference Tables . You
4800-A2-GB20-10