Table of Contents
Advertisement
Connecting Ethernet Connections to the IPC or Ethernet Hubs
Use this procedure for connecting RADSL and MVL cards to the IPC or Ethernet hubs.
For other types of cards, refer to the appropriate Installation Instructions.
"
Procedure
To connect the DSL cards to the Ethernet hubs or switches:
1. Plug the end of an 8-pin modular cable into the appropriate 10 BASE T port of the
8610 chassis. For example, if you want to connect to a DSL card in Slot 2, insert
the 8-pin modular cable into the 10 BASE T Slot #2.
2. Run the 8-pin modular cable under the 8610 chassis and behind the left leg.
3. Plug the other end of the cable into your Ethernet hub or switch connector.
5
4
6
3
2
1
STACK
POSITION
To Hub Connector
Connecting to an SNMP Management System
"
Procedure
To connect the Hotwire 8610 DSLAM base chassis (i.e., the chassis that contains the
MCP card) to an SNMP management system:
1. Plug the end of an 8-pin modular cable into the MCP/1 port of the Hotwire 8610
DSLAM base chassis.
2. Dress the 8-pin cable under the 8610 chassis to the left and behind the left support
foot.
3. Plug the other end of the cable into the 10BaseT hub connector to the SNMP
management system network.
POSITION
To SNMP
Management System
MANAGEMENT
IN
OUT
SERIAL
MANAGEMENT
5
6
4
3
2
1
STACK
IN
OUT
10 BASE T
ALM INTF MCP/1
2
99-16323
10 BASE T
SERIAL
ALM INTF MCP/1
22
3
3
2
99-16324
Advertisement
Table of Contents
