Configure Security - Paradyne BitStorm 4800 User Manual

Configure Security

The configure security command limits access to the system.
See
Table A-14. Configure Security Command (1 of 3)
4800-A2-GB20-10
IP Security on page A-38 for a detailed description of the IP security table.
configure security ip { port_id } {disabled | enabled}
Minimum Access Level: Administrator
The configure security ip command determines whether there is a limit on the number of
IP addresses associated with a DSL port. For more information see
page A-38.
port_id – Identifies the DSL port to be affected. The possible forms of the identifier are
described in Chapter 2, Terminology and Conventions
disabled – Specifies that there are no restrictions on the number of IP addresses on the
specified port. This is the default.
enabled – Specifies that there are restrictions on the number of IP addresses allowed on
the specified port. The system must be in multiplex forwarding (mux) mode, else the
following message is displayed:
Command not allowed: System must be in mux forwarding mode
See Table A-4, Configure Bridge Command
Example:
IAC#configure security ip 1/1 enabled
configure security ip { port_id } add { ip_address } { nhr_address }
Minimum Access Level: Administrator
The configure security ip add command specifes an IP address allowed to be active on
a particular DSL port. For more information see
port_id – Identifies the DSL port to be affected. The possible forms of the identifier are
described in Chapter 2, Terminology and Conventions
ip_address – Specifies an IP address allowed to be active on the port. If the table of
allowed IP addresses already has the number of addresses specified by the configure
security IP max-ip command, the following error message is displayed:
Command not allowed: Too many static entries
nhr_address – Specifies the address of the Next Hop Router for this port. It overrides the
default address.
Example:
IAC#configure security ip 1/1 add 135.27.90.2 135.27.90.21
July 2002
A. CLI Command Descriptions
IP Security
.
for information about mux forwarding mode.
IP Security on page A-38.
.
on
A-35