Test - Paradyne BitStorm 4800 User Manual

A. CLI Command Descriptions

Test

The test command initiates tests.
Table A-33. Command
A-72
test dte-loopback {start | stop}
Minimum Access Level: Administrator
The test dte-loopback command places the V.35/X.21 port of the Management Module
in loopback. All data received on the port is returned without modification.
No test results are displayed. You must attach external test equipment to perform a bit
error rate test.
start – Places the V.35/X.21 port in loopback mode.
stop – Returns the V.35/X.21 port to normal mode, terminating the test.
If the command is not issued to stop the test, the test stops automatically after the number
of minutes specified in the test-timeout value of the configure system options
command. See Table A-18, Configure System Options
Example:
IAC#test dte-loopback start
IAC#test dte-loopback stop
test leds
Minimum Access Level: Administrator
The test leds command causes all Light-Emitting Diodes (LEDs) on the front panel of the
unit to turn on for 30 seconds.
See the BitStorm 4800 Installation Guide
are lit. If an LED does not light up during the LED test, notify your service representative.
Example:
IAC#test leds
July 2002
Command.
for the locations of all LEDs. Verify that all LEDs
4800-A2-GB20-10