Configure Sntp - Paradyne BitStorm 4800 User Manual

Configure SNTP

The configure sntp commands define the use of a Simple Network Time Protocol
(SNTP) server to set and update the date in time in the unit. If SNTP is enabled,
the unit makes an SNTP request at initialization and then periodically at the
interval specified by the configure sntp interval command.
Table A-15. Configure SNTP Command
4800-A2-GB20-10
configure sntp {disable | enable}
Minimum Access Level: Administrator
The configure sntp command determines whether the unit makes SNTP requests.
disable – The unit does not make SNTP requests. Date and time must be set manually.
enable – The unit updates the date and time periodically by sending requests to an SNTP
server.
Example:
IAC#configure sntp disable
configure sntp address { ip_address }
Minimum Access Level: Administrator
The configure sntp address command specifies the IP address of an SNTP server.
ip_address – The address of an SNTP server. The default is 192.5.41.40.
Example:
IAC#configure sntp address 137.90.127.40
configure sntp interval { interval }
Minimum Access Level: Administrator
The configure sntp interval command specifies the frequency that the unit should make
SNTP requests to update the date and time.
interval – The period, in hours, between SNTP requests. Valid values are 1–24. The
default is 24.
Example:
IAC#configure sntp interval 12
July 2002
A. CLI Command Descriptions
A-39