Modes Of Operation; Back Command; Automatic Command Completion - Paradyne BitStorm 4800 User Manual

Modes of Operation

You may enter CLI commands in their entirety on one line. For example:
Alternatively, you may logically position the command interface at any point in the
command tree structure by entering partial commands. The prompt shows where
you are in the command structure. For example:
You can move back up the command tree using the back command.

Back Command

The back command positions the CLI up one level in the command tree. For
example, if DSL interface 1/1 is being configured, the following prompt is
displayed:
Each back command positions the interface one level higher:

Automatic Command Completion

Commands and keywords can be abbreviated to as few characters as are required
to make them uniquely identifiable. For example, con is a valid abbreviation for
configure and cop is a valid abbreviation for copy, but the abbreviation co is
ambiguous.
You can request automatic completion of a command or keyword you have
partially typed by pressing the Tab key. If the command or keyword you have typed
is ambiguous, the Tab key displays the options for completion.
4800-A2-GB20-10
IAC#!configure interface dsl 1/1 line-code dmt
IAC#!configure interface dsl 1/1 latency fast
IAC#configure
IAC(configure)#interface
IAC(configure-interface)#dsl
IAC(configure-interface-dsl)#1/1
IAC(configure-interface-dsl-1/1)#line-code dmt
IAC(configure-interface-dsl-1/1)#!latency fast
IAC(configure-interface-dsl-1/1)#
IAC(configure-interface-dsl-1/1)#back
IAC(configure-interface-dsl)#back
IAC(configure-interface)#back
IAC(configure)#_
July 2002
3. Using the Command Line Interface
3-3