Configure Factory - Paradyne BitStorm 4800 User Manual

Configure Factory

The configure factory command loads the factory default parameters into the
running configuration. The default parameters take immediate effect, but are not
saved. Execute the Save command to save the parameters to Non-Volatile
Random-Access Memory (NVRAM).
Factory defaults include a management address of 10.10.10.10, so if you are
managing the BitStorm 4800 using Telnet over a different address, your
connection is terminated upon execution of the configure factory command. It is
therefore recommended that this command be executed from the Console or
Modem port.
Table A-6. Configure Factory Command
4800-A2-GB20-10
configure factory
Minimum Access Level: Administrator
The configure factory command loads factory default parameters.
Example:
IAC#configure factory
July 2002
A. CLI Command Descriptions
A-7