Pdn-Mpe-Device-Control-Mib; Pdn-Mpe-Dslam-System-Mib; Pdn-Mpe-Health-And-Status-Mib; Pdn-Mpe-Entity-Sensor-Mib - Paradyne BitStorm 4800 User Manual

C. MIB Support

PDN-MPE-DEVICE-CONTROL-MIB

The PDN-MPE-DEVICE-CONTROL-MIB is used to reset the device. The
mpeDevControlTable object of the mpeDevHwControl group is supported.
A reset is effected by writing the value reset(2) to the mpeDevControlReset object
of mpeDevControlEntry. The value resetToFactoryDefaults(3) is invalid.

PDN-MPE-DSLAM-SYSTEM-MIB

The PDN-MPE-DSLAM-SYSTEM-MIB is used to configure alarms. It is fully
supported.

PDN-MPE-HEALTH-AND-STATUS-MIB

The PDN-MPE_HEALTH-AND-STATUS-MIB is used to report device self-test
results. It is fully supported.
The mpeDevSelfTestResults object contains the results of self-tests for each
circuit card assembly, separated by semi-colons (;). The results are in the format:
Stack= r
Chassis= r
SecProc= r
Port Processor: SEEP= r ;CPUReg= r ,CPUTimer= r ,SDRAM= r
DSL Ports: Memory= r ;DataPump= r ,PHY= r
Management Module: CPUReg= r ,CPUTimer= r ,SDRAM= r ,File System= r
V.35/X.21 Uplink: CPUReg= r ,CPUTimer= r ,SDRAM= r ,Uplink Interface= r
GigE Uplink Interface: MAC= r ;PHY= r ,Device Reg= r
GigE Uplink Interface: MAC= r ;PHY= r ,Device Reg= r
Management Port: MAC= r ;PHY= r ,Device Reg= r
Etherswitch: I2C Bus = r ;L2 Switch Memory= r ;L2 Switch Reg= r
Where:

PDN-MPE-ENTITY-SENSOR-MIB

The PDN-MPE-ENTITY-SENSOR-MIB is used to configure and read temperature
sensor limits. It is fully supported.
C-48
r is one of:
P = Pass
F = Fail
U = Unknown status
July 2002 4800-A2-GB20-10