Front Panel Leds; Show Commands And Web Interface Status Screens - Paradyne BitStorm 4800 User Manual

5. Monitoring and Troubleshooting

Front Panel LEDs

If you have access to the unit, check the front panel LEDs. These are described in
the
If an LED that should be lit during normal operation is not lit, verify that it is
functional by using the test leds command of the Command Line Interface or the
Diagnostics/Test LEDs screen of the Web interface.

Show Commands and Web Interface Status Screens

The show command of the Command Line Interface and various screens of the
Web interface show the condition of the unit and its interfaces, including error
statistics for the ports. The following table shows how to access the information.
Table 5-2.
5-6
BitStorm 4800 Installation Guide
How to Locate Status Information
For Information
About . . . Use the CLI Command . . .
Bridge show bridge
Filters show filter
Filter Bindings show filter-binding
Filter Rules show filter-rule
Console Port show interface console
DSL Ports show interface dsl port_id
Ethernet Ports show interface ethernet port_id Status/Ethernet Statistics
Modem Port show interface modem
V.35/X.21 Port show interface v35
Management (IP) show management ip
Management (IPsec) show management ipsec
Management (SNMP) show management snmp
Self-Test Results show system selftest
Syslog show syslog
System show system status
Users show user-accounts
July 2002
.
Use the Web Interface
Screen . . .
Status/Bridge
Configuration/Filter
Configuration/Binding
Configuration/Rule
Configuration/Console
Status/DSL Port Statistics
Configuration/Modem
Status/V.35 Statistics
Configuration/Management/
Address
Configuration/IPsec
Configuration/SNMP
System/Self-Test Results
Status/Syslog
Status/System Information
Status/Users
4800-A2-GB20-10