Table of Contents
Advertisement
Installing the Management Module
Each BitStorm 4800 requires a Model 4800 Management Module or a Model 4804
Management Module with V.35/X.21 uplink. If your Management Module was
shipped separately from the BitStorm 4800, install the Management Module
before you connect the BitStorm 4800 to a power source.
Procedure
To install a Management Module:
4821-A2-GN20-00
HANDLING PRECAUTIONS FOR
!
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
1. Remove the two screws holding the slot cover on the BitStorm 4800.
2. Store the slot cover; retain the screws.
April 2002
1. Installation
02-17068
1-13
Advertisement
Table of Contents
