Paging - Paradyne BitStorm 4800 User Manual

Table A-26. Firmware Command (2 of 2)

Paging

The paging command enables and disables the More prompt.
Table A-27. Paging Command
4800-A2-GB20-10
firmware revision
Minimum Access Level: Administrator
The firmware revision command displays the revision numbers of the firmware currently
running and alternate firmware maintained in memory.
Example:
IAC#firmware revision
firmware switch
Minimum Access Level: Administrator
The firmware switch command loads and executes the alternative firmware file. This
resets the BitStorm 4800.
Example:
IAC#firmware switch
IAC#Switch from firmware revision S01.02.03 to firmware revision
S01.02.04? (yes/no) yes
IAC#Firmware switched, system rebooting
paging {disabled | enabled}
Minimum Access Level: User
The paging command determines how a full screen of output is displayed. The selection
affects only the user who enters the command.
disabled – Specifies that output is sent to the screen without interruption.
enabled – Specifies that when 23 lines of output have been sent to the screen, a More
prompt is displayed on line 24. When More is displayed, you can:
– Press the space bar to view the next screen of output
– Press the Enter key to view the next line of output
Example:
IAC>paging enabled
July 2002
A. CLI Command Descriptions
A-49