Exit - Paradyne BitStorm 4800 User Manual

A. CLI Command Descriptions

Exit

The exit command terminates the user session.
Table A-25. Exit Command
Firmware
The firmware command downloads and applies new firmware to the
BitStorm 4800, and displays the version numbers of the active and alternate
firmware.
Table A-26. Firmware Command (1 of 2)
A-48
exit
Minimum Access Level: User
The exit command terminates the user session. If the user session is by telnet, the
connection is dropped.
Example:
IAC#exit
firmware download { ip_address } { user_name } { password } { filename }
{no | yes}
Minimum Access Level: Administrator
The firmware download command downloads new firmware to the BitStorm 4800, and
optionally applies it immediately.
ip_address – Specifies the network address of the FTP server.
user_name – Specifies a user name accepted by the FTP server.
password – Specifies the password associated with the user name.
filename – Specifies the file containing the configuration backup.
no – The file is downloaded to the alternate firmware area, but not applied or executed.
yes – The file is downloaded and applied immediately. The BitStorm 4800 is reset.
Example:
IAC#firmware download 135.27.90.98 admin admnpass firm0302.bin no
firmware download-status
Minimum Access Level: Administrator
The firmware download-status command displays the status of the active or last
firmware download.
Example:
IAC#firmware download-status
July 2002 4800-A2-GB20-10