Configure Filter-Binding - Paradyne BitStorm 4800 User Manual

Configure Filter-Binding

The configure filter-binding command associates a filter with a particular port, or
removes such an association.
Table A-8. Configure Filter-Binding Command
4800-A2-GB20-10
configure filter-binding create filter_name
{outbound | inbound | both} port_id
Minimum Access Level: Administrator
The configure filter-binding create command associates a filter to a port.
filter_name – Specifies the filter to be associated with a port. It must exist. (See
Configure Filter on page A-8.)
outbound – Specifies that traffic from the port is affected by the filter.
inbound – Specifies that traffic to the port is affected by the filter.
both – Specifies that traffic both to and from the port is affected by the filter.
port_id – Specifies the DSL port whose traffic is to be filtered.
Example:
IAC#configure filter-binding create no_at_or_ipx 1/1
configure filter-binding delete filter_name
{outbound | inbound | both} port_id
Minimum Access Level: Administrator
The configure filter-binding delete command removes the association of a filter to a
port.
filter_name – Specifies the filter whose association is to be deleted. The filter itself
remains intact.
outbound – Specifies that traffic from the port is affected by the filter whose binding is to
be deleted.
inbound – Specifies that traffic to the port is affected by the filter whose binding is to be
deleted.
both – Specifies that traffic both to and from the port is affected by the filter whose binding
is to be deleted.
port_id – Specifies the DSL port whose filter is to be deleted.
Example:
IAC#configure filter-binding delete no_at_or_ipx 1/1
July 2002
A. CLI Command Descriptions
A-9