Configure Uplink - Paradyne BitStorm 4800 User Manual

A. CLI Command Descriptions

Configure Uplink

The configure uplink command determines whether the GigE Uplink port or the
V.35/X.21 port on the Management Module is used for the uplink. If the
Management Module has a V.35/X.21 port, the V.35/X.21 port is the default uplink.
This command therefore allows you to override the default by specifying the GigE
Uplink port as the uplink.
Table A-19. Configure Uplink Command
A-44
configure uplink {gige-uplink | module}
Minimum Access Level: Administrator
The configure uplink command determines the port used for the uplink.
gige-uplink – The uplink is the GigE Uplink Ethernet port.
module – The uplink is the V.35/X.21 port on the Management Module.
Example:
IAC#configure uplink gige-uplink
July 2002 4800-A2-GB20-10