Configure Scheduler - Paradyne BitStorm 4800 User Manual

Configure Scheduler

The configure scheduler command sets parameters for automatic backup.
Table A-13. Configure Scheduler Command (1 of 2)
4800-A2-GB20-10
configure scheduler {disabled | enabled}
Minimum Access Level: Administrator
The configure scheduler command determines whether automatic configuration backup
occurs.
disabled – Specifies automatic configuration backup will not occur. This is the default.
enabled – Specifies that automatic configuration backup will occur.
Example:
IAC#configure scheduler enabled
configure scheduler dynamic [ hh:mm ]
Minimum Access Level: Administrator
The configure scheduler dynamic command specifies that automatic configuration
backup will occur after each configuration change.
hh:mm – Specifies the amount of time after a configuration change that a configuration
backup will automatically occur. Time is specified in hours (1–24) and minutes (0-59)
separated by a colon. The default and minimum is 00:30 (30 minutes).
Example:
IAC#configure scheduler dynamic 24:00
configure scheduler fixed {daily | monday | tuesday |
wednesday | thursday | friday | saturday | sunday} { hh:mm }
Minimum Access Level: Administrator
The configure scheduler fixed command specifies the fixed times at which configuration
backups will occur.
day_of_week – Specifies the day of the week backups will occur. If daily is selected, a
backup occurs every day.
hh:mm – Specifies the time of day the backup will occur. Time is specified in hours (1–23)
and minutes (0–59) separated by a colon.
Example:
IAC#configure scheduler sunday 00:00
July 2002
A. CLI Command Descriptions
A-33