Configure Interface - Paradyne BitStorm 4800 User Manual

Configure Interface

The configure interface command sets parameters for the Console, DSL,
Ethernet, Modem, and V.35/X.21 interfaces.
Table A-10. Configure Interface Command (1 of 11)
4800-A2-GB20-10
configure interface console data-bits {7 | 8}
Minimum Access Level: Administrator
The configure interface console data-bits command sets the number of data bits in a
byte on the Console port.
data-bits – Valid choices are 7 and 8. The default is 8.
Example:
IAC#configure interface console data-bits 7
configure interface console parity {even | none | odd}
Minimum Access Level: Administrator
The configure interface console parity command sets the parity bit type for the Console
port.
parity – Valid choices are none, odd, and even. The default is none.
Example:
IAC#configure interface console parity even
configure interface console rate {1200 | 2400 | 4800 | 9600
| 19200 | 38400 | 57600 | 115200}
Minimum Access Level: Administrator
The configure interface console rate command sets the rate of the Console port in bps.
rate – Valid rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200. The
default is 9600 bps.
Example:
IAC#configure interface console rate 57600
configure interface console show
Minimum Access Level: Administrator
The configure interface console show command displays parameters for the Console
port without leaving configuration mode.
Example:
IAC#configure interface console show
July 2002
A. CLI Command Descriptions
A-11