Zc Shroud Assembly And Installation - kozy heat 911XL Installation Manual

ZC SHROUD ASSEMBLY AND INSTALLATION

Shroud assembly includes: (1) Shroud top
(1) Shroud left side
(1) Shroud right side with on/off rocker switch mounting hole
You will also require a grill set or a clean face frame (sold separately).
911XL / 911XL-RAD : You will need the following items from insert components packet: Rocker Switch Wires and On/Off Rocker
Grill option: Remove nuts from upper grill. Place grill rods through holes in shroud top section. Secure with nuts. If necessary, recess
upper grill by re-positioning in one of three mounting holes.
Clean Face frame option: Follow instructions included with clean face frame.
1. Secure right and left shroud sections to top section by aligning (2) holes in side sections to holes in top section. Secure with phillips
head screws (2 ea. side).
OPTIONAL Attach shroud extensions by aligning slots in shroud with desired hole in shroud extension. Secure with phillips head screws.
Grill attachment holes
Phillips head screws
Figure 13a
911XL / 911XL-RAD: Snap rocker switch into place on shroud. Slide one connector on each rocker switch wire to the rocker switch.
2. Attach shroud to insert by placing tabs on left and right shroud pieces into slots in insert. The shroud will set into place.
911XL / 911XL-RAD: Slide remaining connectors on rocker switch wires to terminals on gas valve marked TH / THTP.
Grill option: Remove nuts from lower grill, insert grill bolts through lower hinges on insert. Attach and tighten nuts.
Tabs
Holes
Figure 13b
(8) Phillips head screws
(2) Shroud extensions
13
Attach shroud extensions by aligning slot in
shroud with desired hole in shroud extension.
Secure with phillips head screws.