Piece Shroud Assembly And Installation - kozy heat Chaska CSK-31 Installation And Operation Manual

3 PIECE SHROUD ASSEMBLY AND INSTALLATION

NOTE: If installing a Full Door Shroud, follow instructions included with component.
Shroud assembly includes:
1. Remove glass assembly from fireplace.
2. Lay shroud sections face down on a protective surface to assemble.
Noting orientation of leg sections in photo at right, attach leg sections to top section
by aligning holes (2 ea. side) in top section with holes in leg sections. Secure with
black phillips head sheet metal screws (2 ea. side).
3. Partially thread remaining (2) black phillips head sheet metal screws into holes
located along bottom flange of top section (1 ea. side). Do not tighten at this time.
4. Align leg section holes to corresponding mounting nuts in mounting brackets on
sides of fireplace opening. Secure with phillips truss head screws (2 ea. side).
5.
Install upper hood with flanged ends. Align slots in hood to partially threaded screws
in shroud top, slide hood back. Tighten screws.
6. Attach lower grill by threading 1" phillips head screws through mounting nuts (1 ea.
side) on grill and into corresponding holes located at bottom of shroud leg sections.
Tighten screws.
NOTE: When completed, lower grill may be adjusted slightly from side to side.
(1) Shroud top (2) 10-24 x 1" RH Philips Mch Screw (#300388)
(1) Shroud left side (6) 8 x 3/8" Phillips PH-Type B Blk Zinc SMS (#300121)
(1) Shroud right side (4) 10-24 x 1/2" PH Phillips Truss head Screw BZ (300338-1)
You will also need flanged upper hood and lower grill (included with fireplace).
PAGE 18
2-3
Partially threaded screw. (1) ea. side.
4
5
6
Figure 18a