Zc Shroud Assembly And Installation - kozy heat Jackson 911 Installation And Operation Manual

ZC SHROUD ASSEMBLY AND INSTALLATION

Shroud assembly includes: (1) Shroud top
(1) Shroud left side
(1) Shroud right side with on/off rocker switch mounting hole
You will need a grill set or a clean face frame (sold separately).
911 / 911-RAD : You will need the following items from insert components packet: Rocker Switch Wires and On/Off Rocker Switch.
Grill option: Remove nuts from upper grill. Place grill rods through holes in shroud top section. Secure with nuts. If necessary, recess
upper grill by re-positioning in one of three mounting holes.
Clean Face frame option: Follow instructions included with clean face frame.
1. Secure right and left shroud sections to top section by aligning (2) holes in side sections to holes in top section. Secure with phillips
head screws (2 ea. side).
OPTIONAL: Attach shroud extensions by aligning slots in shroud with desired hole in shroud extension. Secure with phillips head screws.
Figure 21a
911 / 911-RAD: Snap rocker switch into place on shroud. Slide one connector on each rocker switch wire to the rocker switch.
2. Attach shroud to insert by placing tabs on left and right shroud pieces into slots in insert. The shroud will set into place.
911 / 911-RAD: Slide remaining connectors on rocker switch wires to terminals on gas valve marked TH / THTP.
Grill option: Remove nuts from lower grill, insert grill bolts through lower hinges on insert. Attach and tighten nuts.
Figure 21b
(8) Phillips head screws
(2) Shroud extensions
PAGE 21